Darkglass B7K gives you a dynamic bass overdrive sound. Equipped with 4-band EQ and DI features. V2 has the same basic sound as the original with more control over mid frequencies.
Level: Sets output volume level.
Drive: Sets the amount of saturation/overdrive.
Blend: Mixes clean signal into the fuzz signal. Clean sound always stays at unity gain, whereas the volume of the fuzz is determined by the Level control.
Grunt Switch: Three-position switch that controls the amount of low frequencies going into the clipping section of the pedal.
Attack Switch: Three-position switch that controls the amount of high frequencies. Boost position enhances high frequencies and gives you more clarity, Flat position leaves the high frequencies untouched and Cut position cuts high frequencies.
Low, Lo Mids, Hi Mids and Treble: EQ controls for the pedal. Each control has the ability to cut or boost the controlled frequency +/-12 desibels. Frequencies are: Low 100 Hz, Low Mid 1 kHz (or 500 Hz, can be altered with the switch next to the control), Hi Mid 3 kHz (or 1.5 kHz, can be altered with the switch next to the control), Treble 5 kHz.
Ground Lift: If you experience noise and hum problems caused by ground loops, press this switch.
Outputs: Output, Direct Output (balanced XLR output for mixer) and Parallel Output (clean signal output without overdrive).
- Power requirements: 2.1mm 9V DC centre negative power supply. 30 mA.
- True Bypass
- Made in Finland